Description

CRIJNS - Turbo Nozzle For Wheelboxes + D12 Connector:

The Carbon Collective Arch Blaster Turbo is specifically designed for use in wheel wells (arch liners) made of plastic and similar materials, as well as applications on the underside of bodywork and deep components ranging from wishbones to engine blocks. With a finish in the same color as our stainless steel puller and made of soft-touch plastic, this nozzle leaves no marks on contact with both wheels and bodywork.

How do I use CRIJNS - Turbo Nozzle For Wheel Covers + D12 Connector?

1. Plug in the pressure washer and wear nitrile gloves.
2. Snap the mouthpiece onto the Short Trigger Gun with 1/4th connection.
3. Target wheel wells, underside, and engine parts.
4. Set the pressure washer to max. 3600 PSI / 250 bar and max. 60 °C / 140 °F.
5. Keeping a safe distance, move evenly for thorough cleaning.
6. Turn off, disconnect, and rinse the nozzle thoroughly.

Features CRIJNS - Turbo Nozzle For Wheelboxes + D12 Connector:

• Specifically designed for wheel wells and hard-to-reach areas.
• Maximum pressure: 3600 PSI / 250 bar.
• Maximum temperature: 60 °C / 140 °F.
• Color finishing without leaving traces.
• Quick installation with 1/4″ quick release fastener.

Warnings:

• Avoid aiming at people, animals, or fragile objects.
• Prevent surface damage by maintaining proper settings and spacing.
• Always wear nitrile gloves for your safety.
• Avoid targeting painted surfaces unless the intent is to specifically remove paintwork.

Please note the following general instructions:

• Check that the surface is cool.
• Always test the product in an inconspicuous location first to verify compatibility.
• Before use, verify that the product is suitable for your specific application.
• This product information is for non-binding advice only.
• No liabilities can arise from this.

Additional information