Description

Koch Chemie Panel Preparation Spray:

Koch Chemie Panel Preparation Spray (Pps) is an instant cleaner based on isopropanol-alcohol, specially developed for the precise preparation of automotive paint before the application of protective products. It effectively removes polishing oils, wax, sealants and other polish residues. Cleaning the surface with Koch Chemie Pss makes it possible to inspect the paintwork for the presence of holograms and scratches. This step is essential after polishing and before applying protective coatings such as wax, sealants or ceramic coating (for example C0.02, 1K, W0.01).

How do I use Koch Chemie Panel Preparation Spray?

1. Preparation for polishing:
   • Before you begin polishing, thoroughly clean the surface to ensure that no dirt, dust, fingerprints, grease or other contaminants are present.
   • Koch Chemie Panel Preparation Spray (Pps) is specially developed for this task. It effectively removes oils, waxes and polish residues, leaving the surface perfectly clean and ready for polishing.

• • In addition, the use of Pps makes it possible to clearly see holograms and scratches (if any) on the surface. This is crucial for assessing paint condition and determining whether further polishing is needed.

1. During polishing treatment:
   • After each polishing session on the panel (30 x 30 cm), spray the product on the polished surface to break down the oils and haze, and remove them safely using a microfiber cloth.
   • It is wise to repeat this step with each polishing session and use several new microfiber cloths to ensure the effectiveness of the product.

3. Preparation for applying protection:
   • After polishing is complete and the surface is free of scratches and holograms, it is time to apply protective products.
   • It is recommended to thoroughly clean the polished vehicle again with Panel Preparation Spray after several polishing passes. To do this, use the spray twice and be sure to use several new microfiber cloths for optimal results.
   • After the final cleaning of the car with Pps, it is recommended to wait 15 minutes for the isopropanol alcohol to evaporate. Then the surface is ready for the application of wax, sealant or ceramic coating.

Warnings:

• We recommend performing multiple polishing steps to achieve the desired finish before applying a wax or ceramic coating.
• When using rotary polishers, it is important to pay close attention to the heat build-up on the surface. If you do a lot of correction work in a specific place, it is wise to take regular breaks to allow the panel to cool down.

Features Koch Chemie Panel Preparation Spray:

• Powerful degreaser
• Suitable for use on metal, plastic and hard automotive paints
• Isopropanol-alcohol based
• Removes oil, wax and polish residues
• Holograms and scratches become visible
• Use for applying wax, sealant or coating

Please note the following general instructions:

• Polishing should be done only with the necessary experience and with correct equipment.
• If explanations are needed consult our help.
• Always test the product in an inconspicuous location first to verify compatibility.
• Before use, verify that the product is suitable for your specific application.
• This product information is for non-binding advice only.
• No liabilities can arise from this.

Additional information